Kenwood KRF-V5090D Instruction Manual

Also see for KRF-V5090D: Instruction manual Service manual

7 ENSetting up the systemMake connections as shown in the following pages.When connecting the related system components, besure to refer to the instruction manuals supplied withthe components you are connecting.Do not connect the power cord to a wall outlet until allconnections are completed.Notes1. Be sure to insert all connection cords securely. If their connections areimperfect, the sound may not be produced or there will be noiseinterference.2. Be sure to remove the power cord from the AC outlet before pluggingor unplugging any connection cords. Plugging/unplugging connectioncords without disconnecting the power cord can cause malfunctionsand may damage the unit.3. Do not connect power cords from components whose powerconsumption is larger than what is indicated on the AC outlet at therear of this unit.Analog connectionsAudio connections are made using RCA pin cords. These cables transferstereo audio signal in an “analog” form. This means the audio signalcorresponds to the actual audio of two channels. These cables usuallyhave 2 plugs at each end, red for the right channel and white for the leftchannel. These cables are usually packed together with the source unit,or are available at your local electronics retailer.Input mode settingsCD/DVD, VIDEO2 and DVD/6CH inputs each include jacks for digitalaudio input and analog audio input.After completing connections and turning on this model, follow thesteps below.1 Use the INPUT SELECTOR knob to select CD/DVD, VIDEO2,DVD/6CH.2 Press the INPUT MODE key.Each press switches the setting as follows:In DTS play mode1 F-AUTO (digital input, analog input)2 D-MANUAL (digital input)In CD/DVD, VIDEO2, DVD/6CH play mode1 F-AUTO (digital input, analog input)2 D-MANUAL (digital input)3 6CH INPT (DVD/6CH input)4 ANALOG (analog input)Digital input:Select this setting to play digital signals from a DVD, CD, or LDplayer.Analog input:Select this setting to play analog signals from a cassette deck, VCR,or record player.Auto detect:In “F-AUTO” (full auto) mode (AUTO DETECT and DIGITALindicators light up), this model detects the digital or analog inputsignals automatically. Priority is given to digital signal during inputmode selection. This model will select the input mode and listeningmode automatically during playback to match the type of inputsignal (Dolby Digital, PCM, DTS ) and the speaker setting. The initialfactory setting is full auto.To keep this model set to the currently selected listening mode, usethe INPUT MODE key to select “D-MANUAL” (digital manual).However, even when this setting is selected, there may be casesin which the listening mode is selected automatically to match aDolby Digital source signal depending on the combination of listeningmode and source digital.In D-MANUAL mode, if the audio reproduction stops in the middledue to change in the input signals etc, press the LISTEN MODE key.If the INPUT MODE key is pressed quickly, sound may not beproduced. Press the INPUT MODE key again.INPUT MODEINPUT SELECTORLISTEN MODEMicrocomputer malfunctionIf operation is not possible or an erroneous display appears, eventhough all connections have been made properly, reset themicrocomputer by referring to “In case of difficulty”. ‹