Kenwood KRF-V7090D Instruction Manual

Also see for KRF-V7090D: Service manual

23 ENENGLISHRecordingRecording audio (digital sources)Switch on the REC MODE to record a digital input source.Usually use the REC MODE AUTO to record audio input sources. Whenthe digital mode changes during recording in the REC MODE AUTO, theaudio input source may be interrupted momentarily.Recording music in REC MODE AUTO or MANUALInput Selector keysInput SelectorkeysDIMMER1 Use the Input Selector keys to select the source (CD/DVD, DVD/6CH, VIDEO 2, VIDEO 3) you want to record.2 Set the MD or TAPE recorder to record.3 Press and hold the DIMMER key for more than 2 seconds to selectthe REC MODE AUTO or MANUAL.1 REC MODE off : The digital input record mode is switchedoff.2 REC MODE AUTO : The digital input signals (DTS, Dolby Digi-tal, or PCM) are identified automaticallyand converted into stereo signals thatare ready for recording.3 REC MODE MANUAL : The input signal type at the moment thismode is selected is held throughout thismode.• When the REC MODE MANUAL is selected, the digital input signalis converted to stereo signals (down-mix). But once the digital signalis changed to other signal, no signal is output.When the REC MODE AUTO is selected, the digital input signal isconverted to stereo signals even if the digital signal is changed.For REC MODE AUTO :LS SBSL SRC RSP MUTEA B CLIPLFELS SBC RSP MUTEA B CLIPLFESL SRDIGITAL STEREOAUTO DETECTDIGITAL STEREOAUTO DETECTFor REC MODE MANUAL :LSL S SB SRC RLFESP MUTEA B CLIPDIGITAL STEREOLSL S SB SRC RLFESP MUTEA B CLIPDIGITAL STEREO4 Start playback, then start recording.• If the audio reproduction stops in the middle due to change in theinput signals, etc., press the DIMMER key.