Kenwood KRF-V7773D User Manual

Also see for KRF-V7773D: Instruction manual Connect and set up Service manual Service manual

24Using ReceiverHow Do I Adjust the Sound?Setting a DSP effectPress the receiver’s LISTEN MODE key or Remote Control unit’s LIS-TEN M. key repeatedly until the desired listen mode is displayed.• The DSP mode can be set to Arena, Jazz Club, Stadium, Cathedralor Theater.• The DSP mode can be selected only when the current input is PCM(except for 96k fs) or Analog.To customize the DSP effect:1. Press the SOUND key and press the Next key repeatedly until “DSPWall Type” is displayd on Remote Control unit.2. Press the LCD cursor up/down ( / ) key on Remote Control unitto select Soft, Medium or Hard.3. Press Remote Control unit’s Next key to display DSP Room Size.4. Press the LCD cursor up/down ( / ) key on Remote Control unitto select Small, Medium or Large.5. Press Remote Control unit’s Next key or the receiver’s SOUND key todisplay DSP Effect Level.6. Press the LCD cursor up/down ( / ) key on Remote Control unitto select one of Level 1 to Level 5. then press the HOME key.Operating on the receiver:1. Press the SOUND key repeatedly until to display DSP Wall type.2. Press the MULTI CONTROL (%/fi) key to select SOFT, MEDIUM orHARD.3. Press the SOUND key to display DSP Room Size.4. Press the MULTI CONTROL (%/fi) key to select SMALL, MEDIUMor LARGE.5. Press the SOUND key to display DSP Effect Level.6. Press the MULTI CONTROL (%/fi) key to select one of Level 1 toLevel 5, then press the SOUND key repeatedly until “SOUND FIXED”is displayed.Listen ModeDSPArena F.Auto25Using ReceiverHow Do I Adjust the Sound?HDCD® and D.R.I.V.E. EffectsHDCD is a new format enabling recording with higher quality than pre-vious CD while maintaining compatibility with it. Although a HDCD-compatible CD player is usually required to exhibit the full characteris-tics of the HDCD, this receiver is capable of reproducing high-qualityHDCH signals by connecting a CD player through digital connection,even if it does not incorporate the HDCD circuitry.D.R.I.V.E. is a KENWOOD original technology for reproducing signalswith high resolution by instant switching of the internal digital adaptivefilters according to the input signal. This receiver incorporate a highperformance DSP to provide very high resolution from 32-bit DRIVE IIIcircuitry, achieving stereo audio reproduction with the best quality everreached.The D.R.I.V.E. indicator lights when the D.R.I.V.E. circuit is activated.The HDCD indicator lights when the HDCD circuit is activated and aHDCD is played.HDCD and D.R.I.V.E. are designed to be activated automatically to selectthe optimum circuit path., HDCD®, High Definition Compatible Digital® and PacificMicrosonics TM are either registered trademarks or trademarks of PacificMicrosonics, Inc. in the United States and/or other countries. HDCD sys-tem manufactured under license from Pacific Microsonics, Inc. This prod-uct is covered by one or more of the following: IN the USA: 5,479,168,5,638,074, 5,640,161, 5,808,574, 5,838,274, 5,854,600, 5,864,311,5,872,531, and in Australia: 669114. Other patents pending.HDCD and D.R.I.V.E. is effective only at the time of digital input stereoor DSP mode.Some HDCD-recorded discs do not contain all tracks as HDCD recordings.(The HDCD indicator will not light for tracks not recorded as HDCD.)