42Using ReceiverHow Do I Adjust the LCD Display?Using Remote Control unit under low lightWhen using Remote Control unit under low light, the back light of theLCD display can be turned on.• Press and hold the F.SHIFT key for more than 2 sec-onds.The back light is turned on and off every 2 seconds ofholding.If the is blinked, the back light cannot be turned onbecause the batteries are nearly exhausted.Adjusting the contrast of LCD displayThe contrast of the LCD display can be adjusted to improve the visibility.1. Press the Music key or Movie key to display “Menu”.2. Press the Menu (LCD function key 2) key.3. Press the Setup (LCD function key 2) key.4. Press the LCD cursor up/down ( / ) key to select “03. Contrast”,then press the Enter key.5. Select the desired contrast with the LCD cursor up/down ( / )key. The previous menu re-appears in about 3 seconds after the aboveoperation.1 2 34 5 67 8 910 11 12+10 0 +100/8/711How Do I Adjust the LCD Display?43Using ReceiverAdjusting the brightness of receiverWhen the ambient light is low, for example in the night, the brightness ofthe receiver’s display can be dimmed and LED indicators (DTS, 96k fs,HDCD, DOLBY DIGITAL, MPEG and D.R.I.V.E. only) can be disabled.• Press the F.SHIFT = LISTEN M. (DIMMER)* keys. Each press of theLISTEN M. key switches the brightness as shown below.1 Display/bright Indicators/enabled2 Display/dim Indicators/enabled3 Display/dim Indicators/disabledSelecting the display mode of receiver front panel• Press and hold the LISTEN MODE key on the receiver for more than2 seconds.The displayed information is switched every 2 seconds of holding thekey.A: Connected Device Input TypeDVD AUTOB: Input Terminal Connected DeviceVIDEO3 : DVDC: Listen ModeDOLBY DIGITAL"Input Type" is displayed only when a selector with digital input is se-lected.When the input mode is PHONO, TUNER or AV AUX, the connecteddevice and listen mode are displayed alternately.How Do I Adjust the LCD Display?* When an operation is described as [F.SHIFT = LISTEN M. (DIMMER)key], for example, press the F.SHIFT key and press the next key (the LIS-TEN M. (DIMMER) key in this case) within 8 seconds.