Kenwood KRF-X9080D Instruction Manual

Also see for KRF-X9080D: Service manual

40 ENENGLISHBasic remote control operations for other componentsOperating other componentsThis operation lets you operate the registered components.1Use the Source keys to select the component you desire.• Pressing the source keys also changes the input selector on thereceiver.2Press the SRC Power key.• To return to the receiver operation mode, press the TUNER key formore than 3 seconds.3Press the operation keys you desire. uThe remote control mode remains at the selected input. If youwish to operate another component, repeat step 2 or 3.Resetting the Remote Control• To initialize the remote control, press the Learn key until theblinks twice. Then press the Numeric key to enter 9, 8, 1. Thewill blink twice.4Repeat step 3three more times for the remaining digits. Use“2” for the second digit, “3” for the third digit, and “4” for thefourth digit.5To check the codes of your other components, repeat steps1through 4, but substitute the appropriate key (i.e.,DVD/6CH, CD/DVD, VID1, VID2, VID3, TV, MD/TAPE, AV AUX,PHONO) for the component you are checking.• As suggested earlier on, write down each of the four-digit code.• PHONO key has to be re-assigned to another key before a setupcode can be programmed.Re-assigning device keysThe remote control can be setup to control second TV or VCR, or anycombination of eight home entertainment components.For example, to control the operation of two different VCR using theremote control, the user need to re-assign the unused VID2 key tooperate the second VCR(VID1) as follows:1Press and hold the Learn key until blinks twice, thenrelease the Learn key.2Press the Numeric key to enter 9, 9, 2.• will blink twice.3Press VID1 key once, then press the VID2 key once.• The user now can operate VID2 as a second VCR along with VID1.• Refer to the table in the previous page for the combination ofsource keys and the other components assignment. ·4To re-assign other device keys, repeat steps 1through 3bysubstituting the key sequence from the below chart for themost popular components:5To clear the re-assignment and reset the remote control to itsoriginal operation mode:1 Press and hold the Learn key until blinks twice, then releasethe Learn key.2 Press the numeric key to enter 9 , 9 , 2.3 Press VID2 key twice.• When a re-assignment is done, will blink twice to confirmyour choice. At that time, you will need to program the remotecontrol in order to control the new component.• If an invalid key sequence is entered, blink once and return tonormal operation.• When in Tuner mode, re-assignment is not available.To re-assign keySequence PerformTV as 2nd VID1 key Learn 9 9 2 VID1 TVTV as 2nd VID2 key Learn 9 9 2 VID2 TVTV as 2nd CD/DVD key Learn 9 9 2 CD/DVD TVTV back to TV key Learn 9 9 2 TV TVVID1 as 2nd TV key Learn 9 9 2 TV VID1VID1 as 2nd VID2 key Learn 9 9 2 VID2 VID1VID1 as 2nd CD/DVD key Learn 9 9 2 CD/DVD VID1VID1 back to VID1 key Learn 9 9 2 VID1 VID1SRC PowerSourcekeys