Kenwood KVT-925DVD Instruction Manual

Also see for KVT-925DVD: Service manual Service manual

EnglishEnglish 9594 English1. To prevent a short circuit, remove the key from theignition and disconnect the - battery.2. Make the proper input and output wire connections foreach unit.3. Connect the speaker wires of the wiring harness.4. Connect the wiring harness wires in the following order:ground, battery, ignition.5. Connect the wiring harness connector to the unit.6. Install the unit in your car.7. Reconnect the - battery.8. Press the reset button.If you connect the ignition wire (red) and the battery wire(yellow) to the car chassis (ground), you may cause a shortcircuit, that in turn may start a fire. Always connect thosewires to the power source running through the fuse box.• If your car's ignition does not have an ACC position,connect the ignition wires to a power source that can beturned on and off with the ignition key. If you connect theignition wire to a power source with a constant voltagesupply, as with battery wires, the battery may die.• If the console has a lid, make sure to install the unit sothat the faceplate will not hit the lid when closing andopening.• If the fuse blows, first make sure the wires aren’ttouching to cause a short circuit, then replace the oldfuse with one with the same rating.• Insulate unconnected wires with vinyl tape or othersimilar material. To prevent a short circuit, do not removethe caps on the ends of the unconnected wires or theterminals.• Connect the speaker wires correctly to the terminals towhich they correspond. The unit may be damaged or failto work if you share the - wires or ground them to anymetal part in the car.• When only two speakers are being connected to thesystem, connect the connectors either to both the frontoutput terminals or to both the rear output terminals (donot mix front and rear). For example, if you connect the+ connector of the left speaker to a front outputterminal, do not connect the - connector to a rearoutput terminal.• After the unit is installed, check whether the brakelamps, blinkers, wipers, etc. on the car are workingproperly.• Mount the unit so that the mounting angle is 30° or less.2CAUTION2WARNINGInstallation ProcedureBefore InstallationAccessories..........1..........2..........1..........1..........1..........1..........11..........482..........49..........20CAR DIVERSITY ANTENNAWITH BOOSTER CX-A330ONOFFBOOST..........2-..........6=..........1~34567The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessoriesshipped with the unit, as shown above.2CAUTION..........1!