Kenwood NX-200 Instruction Manual

Also see for NEXEDGE NX-200: Brochure Instruction manual Instruction manual Specifications Instruction manual

18SCANScan monitors for signals on the transceiver channels. Whilescanning, the transceiver checks for a signal on each channeland only stops if a signal is present.To begin scanning, press the key programmed as Scan.• The icon appears on the display (NX-200/ NX-300/ NX-200G/NX-300G Only).• The LED blinks green (NX-200S/ NX-300S Only).• When a signal is detected on a channel, Scan pauses at thatchannel. The transceiver will remain on the busy channel until thesignal is no longer present, at which time Scan resumes.To stop scanning, press the Scan key again.Note: To use Scan, there must be at least 2 channels in the scansequence.TEMPORARY CHANNEL LOCKOUTDuring scan, you can temporarily remove specifi c channelsfrom the scanning sequence by selecting them and pressingthe key programmed as Scan Delete/Add.• The channel is no longer scanned. However, when scanning isended and restarted, the channels are reset and deleted channelswill again be in the scanning sequence.PRIORITY SCANNote: To use Priority Scan, a Priority channel must be programmed.When using a single Priority channel, the transceiver willautomatically change to the Priority channel when a call isreceived on that channel, even if a call is being received on anormal channel.When using dual Priority channels, Priority channel 1 is givenprecedence over Priority channel 2. So, if a call is received onPriority channel 1 while a call is already on Priority channel 2,the transceiver will change to Priority channel 1.