Kenwood NX-200 Instruction Manual

Also see for NEXEDGE NX-200: Brochure Instruction manual Instruction manual Specifications Instruction manual

19SCAN REVERTThe Scan Revert channel is the channel selected when youpress the PTT switch to transmit during scan. Your dealer canprogram one of the following types of Scan Revert channels:• Selected: The last channel selected before scan.• Selected + Talkback: Same as “Selected”, plus you canrespond to calls on the channel at which scan is paused.• Priority 1/ Priority 2: The Priority channel (either Priority 1or Priority 2) .• Priority 1 + Talkback/ Priority2 + Talkback: Same as“Priority 1/ Priority 2”, plus you can respond to calls on thechannel at which scan is paused.• Last Called + Selected: The last channel on which youreceive a call.SCAN DELETE/ADDYou can add and remove zones and/or channels/group IDs toand from your scan list.1 Select your desired zone and/or channel/group ID.2 Press the key programmed as Zone Delete/Add (to add/remove zones) or Scan Delete/Add (to add/removechannels/group IDs) (NX-200/ NX-200G/ NX-300/NX-300G Only).• You can also press and hold the key programmed as ScanDelete/Add to add/remove zones.PRIORITY-CHANNEL SELECT(NX-200/ NX-300/ NX-200G/ NX-300G ONLY)If the Priority channel has been set as Operator Selectable byyour dealer, you can reprogram the Priority channels.1 Select your desired zone and channel/group ID.2 Press the key programmed as Priority-channel Select.3 Press / to select “NORMAL”, “PRIORITY 1” ( ),“PRIORITY 2” ( ), or “PRIORITY 1&2” ( ).4 Press to save the setting and exit.