Kenwood NX-200 Instruction Manual

Also see for NEXEDGE NX-200: Brochure Instruction manual Instruction manual Specifications Instruction manual

22■ Reviewing Messages in the Stack Memory(NX-200/ NX-300/ NX-200G/ NX-300G Only)1 Press the key programmed as Stack, or press and holdthe key programmed as Selcall, Status, or Selcall +Status to enter Stack mode.• The last received message is displayed.2 Press / to select the desired message.• Message types are identifi ed as follows:I: Caller ID, S: Status Message, M: Short Message• Press and hold for 1 second or press to cycle thedisplay information as follows:ID Name > Status/Short Message > CH/GID > Time Stamp3 Press to return to normal operation.• To delete the selected message, press or #.To confi rm the deletion, press or .• To delete all messages, press and hold or # for 1 second.To confi rm the deletion, press or .SHORT/LONG MESSAGESReceived short messages are displayed the same as Statusmessages and are stored in the same stack memory (NX-200/NX-300/ NX-200G/ NX-300G Only).To send and receive long messages, you must connect thetransceiver to a PC. Ask your dealer for details.GPS REPORTGPS data can be manually transmitted by pressing the keyprogrammed as Send the GPS data, or by accessing theMenu {page 15}. If set up by your dealer, GPS data may beautomatically transmitted at a preset time interval.• When using the NX-200G/ NX-300G, you must fi rst connect theVHF/ GPS antenna or UHF/ GPS antenna.• When using the NX-200/ NX-300/ NX-200S/ NX-300S, you mustfi rst connect an external GPS unit.