Kenwood NX-700 Service Manual
Also see for NEXEDGE NX-700 series: BrochureFunction referenceInstruction manualInstruction manualSpecifications
                                                                                                             | |
Contents
|
NX-700/700H136-2. Installing the GPS receiver together with the VGS-11. Remove the cabinet, top packing and shielding plate ofthe transceiver.2. Remove the front panel from the transceiver.3. Attach a cushion to the bottom of the VGS-1 as shown inFigure 6-5.Note: Be sure not to cover the connector with the cush-ion.4. Insert the VGS-1 connector (CN1) into the TX-RX unit (A/2)connector (CN595).5. Perform step 3 to 6 of “6-1. Installing the GPS receiver”described on page 13.Note: You must setup using the KPG-111D.TX-RX unit (A/2)Solder landOPT10OPT11AGND26P_RD26P_TDTXD2RXD2OPT1OPT3OPT4OPT55V_1DTIOPT8TXOOPT7OPT2OPT9RXEOTXIRXEIOPT6POW33V5V_2DGNDGPS receiverFig. 6-4CN1CN595GPS receiverVGS-1Fig. 6-5INSTALLATION |
Related manuals for Kenwood NEXEDGE NX-700 series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine