Kenwood NX-700 Service Manual

Also see for NEXEDGE NX-700 series: Brochure Function reference Instruction manual Instruction manual Specifications

NX-700/700H15DISASSEMBLY FOR REPAIR2. Precautions on Reassembly■ TX-RX PCB (TX-RX unit A/2) Reassembly1. With the TX-RX PCB turned over, insert the flat cablefrom the D-sub PCB (TX-RX unit B/2) into the connector(CN600) on the TX-RX PCB.2. Place the TX-RX PCB at its original position, tilt the TX-RXPCB and install the chassis as shown in Figure 3.Fig. 3■ FINAL shield case (F10-2489-13) installationprocedure1. Place the shield case on the final section of the TX-RXunit (A/2).2. The shield case is installed on the positioning boss ofthe chassis by pushing down on “PUSH2” (on the shieldcase) while pushing “PUSH1” (stamped on two parts onthe shield case) to the right.■ Power supply cable installation procedure1. Pass the power supply cable through the chassis hole ( q )as shown in Figure 4-1 and insert the bush into the chas-sis hole.2. Rotate the bush of the power supply cable 90 degreesclockwise as viewed from the rear of the chassis. ( w )3. Align the ignition sense connector (yellow) of the powersupply cable around the chemical capacitor (C401) andconnect it to the TX-RX unit (A/2) connector (CN403).4. Align the + (positive) terminal of the power supply cable(red) as shown in Figure 4-2 and fix it to the terminal stripwith a screw.5. Align the – (negative) terminal of the power supply cable(black) as shown in Figure 4-2 and fix it to the terminalstrip with a screw.@:Fig. 4-1IC403C401IC715CN403BlackRedFig. 4-2■ Top packing installation procedure1. Place the top packing over the shielding plate.2. Fit the convex tab of the top packing into the hollow ofthe chassis. ( q )3. Fit the chassis into the groove of the top packing. ( w )Verify that the top packing is in close contact with thechassis.:@Fig. 5