NX-82061. ModesUser modePC mode Data programming modePC test mode PC tuning modePanel test mode Panel tuning modeClone modeFirmware version informationFirmwareprogramming modeMode FunctionUser mode For normal use.Panel test mode Use by the dealer to check the fundamentalcharacteristics.Panel tuning mode Used by the dealer to tune the transceiver.PC mode Used for communication between the trans-ceiver and PC.Data programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test mode Used to check the transceiver using the PC.This feature is included in the FPU.PC tuning mode Used to tune the transceiver using the PC.Firmware pro-gramming modeUsed when changing the main program ofthe fl ash memory.Clone mode Used to transfer programming data from onetransceiver to another.Firmware versioninformation Used to confirm the internal firmware version.2. How to Enter Each ModeMode OperationUser mode Power ONPanel test mode [ ] + Power ONPanel tuning mode Panel test mode + [ ]PC mode Received commands from PCFirmware programming mode [ ] + Power ONClone mode [ ] + Power ON (One second)Firmware version information [ ] + Power ON3. Panel Test ModeSetting method refer to ADJUSTMENT.4. Panel Tuning ModeSetting method refer to ADJUSTMENT.REALIGNMENT / 模式组合1. 模式模 式 功 能用户模式 一般使用。面板测试模式 用于经销商检查基本功能。面板调谐模式 用于经销商调整车载对讲机指标。PC 模式 用于车载对讲机与 PC 之间的通信。数据编程模式 用于阅读和写入频率数据以及其他功能。PC 测试模式 用于通过 PC 检查车载对讲机。该功能内置于 FPU 中。PC 调谐模式 用于通过 PC 调谐车载对讲机。固件编程模式 当改变闪存中操作主程序时使用。复制模式 用于将一台车载对讲机的编程数据传送到另一台。固件版本信息 用于确认内部固件版本。2. 如何进入每一种模式模 式 操 作用户模式 接通电源面板测试模式 [ ]+ 接通电源面板调谐模式 面板测试模式 +[ ]PC 模式 从 PC 接收指令固件编程模式 [ ]+ 接通电源复制模式 [ ]+ 接通电源 (1 秒钟 )固件版本信息 [ ]+ 接通电源3. 关于面板测试模式关于设定方式,参见调整。4. 关于面板调谐模式关于设定方式,参见调整。⭞ᡭ⁗ᕅ䶘ᶵ⎁䈋⁗ᕅ3& ⁗ᕅ⁗ᕅགྷരԬ⡾ᵢؗᚥ䶘ᶵ䈹䉆⁗ᕅᮦᦤ㕌ぁ⁗ᕅ3& ⎁䈋⁗ᕅ 3& 䈹䉆⁗ᕅരԬ㕌ぁ⁗ᕅ