Page 188 Recalling Memory ChannelsPress the MR key.You can change the memory channel by the following two methods.Using the Tuning ControlRotate the tuning control clockwise or counterclockwise to select the desired Memory Channel.Using the numeric keypadSelect any desired memory channel number (0-49). For example, use a two digit number, such as 02 for channel2, or 15 for cannel 15.If you install the optional ME-1, you cannot recall more than 100 memory channels in the two digits recall mode(initial states). You must change the function to three digit recall mode.1) Press and hold the MR key and turn the power on. The VHF band frequency display changes to the recallselection mode with the numeric keys.2) Select -3 with the right encoder.3) Press any front panel key to return to the normal frequency display.9 Memory ShiftPress the F key, then press the VFO key to copy the contents of a memory or call channel to the VFO withoutchanging the data in memory. Doing this allows you to begin tuning at the point specified by the memory channeldata.CautionYou cannot perform memory shift if the displayed frequency exceeds the programmable VFO settingrange (see page 12).10 Memory Channel Character DisplayYou can display the memory channel frequency with your own spelling. It may be up to six characters long. Youcan use numerics 0 to 9 and the letters A to Z.Function SettingPress and hold the f 2 key, and turn the power on.NoteWhen you select this function, the memory channel can be displayed alphanumerically, but the total numberof available memory channels is halved, i. e., 25. To return to 50 channels, repeat the operation.Character registration1) Press the MR key to enter the memory channel mode.2) Select a desired channel from among the memory channels in which you stored data using the Tuning controlor numeric keypad.