Page 37Relationship between input characters and keys(Note: "+" means press two keys in sequence [within 2 seconds])Input Key Input Key Input Key Input Keycharacters operation characters operation characters operation characters operation0 0 Q 1 + A (F) Z 1 + B (M) (space) 1 + C (f 2)1 1 A 2 + A (F) B 2 + B (M) C 2 + C (f 2)2 2 D 3 + A (F) E 3 + B (M) F 3 + C (f 2)3 3 G 4 + A (F) H 4 + B (M) I 4 + C (f 2)4 4 J 5 + A (F) K 5 + B (M) L 5 + C (f 2)5 5 M 6 + A (F) N 6 + B (M) O 6 + C (f 2)6 6 P 7 + A (F) R 7 + B (M) S 7 + C (f 2)7 7 T 8 + A (F) U 8 + B (M) V 8 + C (f 2)8 8 W 9 + A (F) X 9 + B (M) Y 9 + C (f 2)9 9For exampleC A L L M E2+C 2+A 5+C 5+C 6+A 3+B5) Press a key (0 to 9) corresponding to the numeric you want to enter to memory.6) To cancel message input mode, press the PTT switch.3 Message Memory Check1) Press and hold the F key for longer than one second, then press the MESSAGE key.2) Press a desired key (0 to 9).3) To return to the normal frequency display, press any key (except 0 to 9 key).4 Message Memory Transmission1) Press the PTT switch, then press the MESSAGE key. The MESSAGE indicator will appear on the display.2) Hold down the PTT switch, and press a desired key (0 to 9).3) You can perform steps 1 and 2 any number of times during transmission. Therefore, if you use 10 messagememory channels, you can transmit a text of up to 60 characters.5 Message Reception1) When the DTSS or paging function is on, press the F key, then the MESSAGE key.