Kenwood TK-2107G Service Manual

TK-2107G29ADJUSTMENT / 调整Adjustment Frequency ListCH TX f (MHz) RX f (MHz)Center 162.0000 162.1000Low 150.0000 150.1000Hi 173.9750 173.9000Remarks• Connect the transceiver to the PC• Send the channel data to the transceiver, then backup thedata.• Program the adjustment frequencies which are in the list,into the transciever.Note: Remember to reload the channel data you backed upafter making the adjustments.Setvice Jig■ Jig (chassis) for adjustmentPart number: A10-1392-03■ Use the jig as follows:1. Insert the coaxial antenna connector into the jig.2. Place the unit on the jig and fix it with 12 screws (q).3. Solder the antenna terminal to the terminal of the unit.Note: Supply power from an external power supply.Relay terminal: +, Jig (chassis): –调整频率清单信道发射频率 (MHz) 接收频率 (MHz)中心 162.0000 162.1000低 150.0000 150.1000高 173.9750 173.9000备注• 将对讲机与计算机连接。• 向对讲机发送信道数据，然后备份数据。• 将清单中的调整频率编程，输入对讲机。注意 : 在进行调整后，重新载入备份的信道数据。维修夹具■用于调整的模板 ( 机架 )部件号码 :A10-1392-03■按照下述方法使用模板 :1. 将同轴天线连接器插入模板。2. 将主板放置在模板上，然后用 12 颗螺钉拧紧 (q)。3. 将天线的端点与主板的焊点焊接。注意 : 供电来自于外部电源。继电器端点 :+，模板 ( 机架 ):–Coaxial antenna connector同轴天线连接器Jig / 模板Relay terminal继电器端点TX-RX unitTX-RX 单元:: :: :