Kenwood TK-2200L Service Manual

Also see for TK-2200L: Product brochure Instruction manual

TK-2200L32. How to Enter Each ModeMode OperationUser mode Power ONPC mode Received commands from PCClone mode [PTT]+[Side2]+Power ON (Two seconds)Mode FunctionUser mode For normal use.PC mode Used for communication between thetransceiver and PC (IBM compatible).Data programming Used to read and write frequency datamode and other features to and from thetransceiver.PC test mode Used to check the transceiver using thePC. This feature is included in the FPU.Clone mode Used to transfer programming datafrom one transceiver to another.REALIGNMENT1. Modes 4. PC Mode4-1. PrefaceThe transceiver is programmed using a personal computer,a programming interface (KPG-22/22A), USB adapter (KCT-53U)and programming software (KPG-88D).The programming software can be used with an IBM PCor compatible. Figure 1 shows the setup of an IBM PC forprogramming.4-2. Connection procedure1. Connect the transceiver to the personal computer with theinterface cable and USB adapter (When the interface cableis KPG-22A, the KCT-53U can be used.).Notes:• You must install the KCT-53U driver in the computer to usethe USB adapter (KCT-53U).• When using the USB adapter (KCT-53U) for the first time,plug the KCT-53U into a USB port on the computer with thecomputer power ON.2. When the POWER is switched on, user mode can beentered immediately. When the PC sends a command,the transceiver enters PC mode.When data is transmitting from the transceiver, the redLED lights.When data is received by the transceiver, the green LEDlights.Notes:• The data stored in the computer must match the modeltype when it is written into the EEPROM.• Change the transceiver to PC mode, then attach theinterface cable.4-3. KPG-22/KPG-22A description(PC programming interface cable: Option)The KPG-22/22A is required to interface the transceiver withthe computer. It has a circuit in its D-sub connector (KPG-22 :25-pin, KPG-22A : 9-pin) case that converts the RS-232C logiclevel to the TTL level.The KPG-22/22A connects the SP/MIC connector of thetransceiver to the RS-232C serial port of the computer.4-4. KCT-53U description (USB adapter : Option)The KCT-53U is a cable which connects the KPG-22A to aUSB port on a computer.When using the KCT-53U, install the supplied CD-ROM(with driver software) in the computer. The KCT-53U driverruns under Windows 2000 or XP.AntennaLED indicatorIndicates the transceiverstatus. Lights red whiletransmitting, green whilereceiving, and flashesred while the batterypower is low whiletransmitting.PTT (Push toTalk) switchPress and hold,then speak intothe microphoneto transmit.Side 1 keySide 2 keySpeaker/microphonejacksBattery pack(KNB-45L)Channel selectorRotate to change theoperating channel.Power switch/Volume controlTurn clockwise toswitch the power ONand counterclockwiseto switch the powerOFF. Rotate to adjustthe volume.3. Getting AcquaintedUser modePC modePC test modeData programmingmodePC tuning modeClone mode