Kenwood TK-3302 Service Manual Supplement

Also see for TK-3302: Instruction manual Instruction manual Instruction manual Service manual Service manual

Contents

TK-33023REALIGNMENT1. ModesUser modeData programming modePC test mode PC tuning modePC modeWireless clone modeMode FunctionUser mode For normal use.PC mode Used for communication between the trans-ceiver and PC.Data programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test mode Used to check the transceiver using the PC.This feature is included in the FPU.Wireless clonemodeUsed to transfer programming data fromone transceiver to another.SYSTEM SET-UP2. How to Enter Each ModeMode OperationUser mode Power ONPC mode Received commands from PCWireless clone mode [PTT]+[Side2]+Power ON (Two seconds)3. PC Mode3-1. PrefaceThe transceiver is programmed by using a personal com-puter, a programming interface (KPG-22/22A, USB adapter(KCT-53U)) and FPU (programming software).The programming software can be used with a PC orcompatible. Figure 1 shows the setup of a PC for program-ming.3-2. Connection Procedure1. Connect the transceiver to the personal computer withthe interface cable and USB adapter (when the interfacecable is KPG-22A, the KCT-53U can be used).Merchandise receivedChoose the type of transceiverTransceiver programmingDeliveryAre you using the speaker microphone?A personal computer, programming interface (KPG-22/22A),and FPU (programming software) are required for programming.(The frequency, TX power HI/LOW, and signalling data areprogrammed for the transceiver.)YESNOKMC-17, KMC-21 or KMC-45Speaker microphone(Option)Are you using the optional antenna? YESNOKRA-23 or KRA-27Optional antennaTX/RX 470~512TX/RX 400~4304.0W4.0WFrequency range (MHz) RF power TypeTK-3302: K2,M2TK-3302: K3