Kenwood TK-3302 Service Manual Supplement

Also see for TK-3302: Instruction manual Instruction manual Instruction manual Service manual Service manual

Contents

TK-33025REALIGNMENT4-3. Operation1. To switch the clone target/s to wireless clone mode,press and hold the [PTT] and [side2] keys while turningthe transceiver power ON.2. Wait for 2 seconds. The LED will light orange and thetransceiver will announce “Clone”.3. Select a channel table number using Side1 (incrementchannel table) and Side2 (decrement channnel table)keys.4. To switch the clone source to wireless clone mode, pressand hold the [PTT] and [side2] keys while turning thetransceiver power ON.5. Wait for 2 seconds. The LED will light orange and thetransceiver will announce “Clone”.6. Select the same channel table number as the clonetarget/s.7. Press [PTT] on the clone source to begin data transmis-sion.When the clone target starts to receive data, the LED willlight green.When the clone source finishes sending data, a “confir-mation” tone will sound.If data transmission fails while cloning, an “error” tonewill sound from the target unit.8. If the cloning fails, no data will be available in the targetunit when it is returned to User mode.9. When the cloning is successful, the target unit’s “Scan”and “Key lock” functions will return to their default values(Scan = OFF, Key lock = OFF).Notes:• The dealer can clone data to two or more transceivers byrepeating the above procedures.• If the transceivers wireless clone mode is configured as“Disabled”, the transceiver cannot enter wireless clonemode.• The table shown below will cover the frequency tablesused for wireless cloning.• Wireless clone mode cannot be entered in battery lowstate.• A unit cannot be a “Source Unit” if it is unprogrammed. If[PTT] is pressed, an “error” tone will sound.• The language used in cloning depends on the “Modeltype” setting, not the FPU setting.• Once a unit is set to be the source, it cannot be a targetafter the data has been transmitted. This protects thedata in the source unit.• Electronic interface may cause a failure in data transferduring wireless clone, such as when waveforms or elec-tromagnetics are being performed at the workbench.• Wireless clone mode can be used ONLY by the autho-rized service personnel.• The wireless clone mode setting must be configuredas “Disable” before being delivered to the end-user.• To clone, replace the antenna from both the sourcetransceiver and the target transceiver with a dummyload.• The transmit output power is automatically set toLow in wireless clone mode.• Clone frequency tableNo.Operating frequency (MHz)TK-3302 K2,M2 TK-3302 K3470~512 400~4301 472.000 400.0002 474.000 401.0003 476.000 402.0004 478.000 403.0005 480.000 404.0006 482.000 405.0007 484.000 406.0008 486.000 407.0009 488.000 408.00010 490.000 409.00011 492.000 410.00012 494.000 411.00013 496.000 412.00014 498.000 413.00015 500.000 414.00016 502.000 415.00017 504.000 416.00018 506.000 417.00019 508.000 418.00020 510.000 419.000