Kenwood TK-3302 Service Manual Supplement

Also see for TK-3302: Instruction manual Instruction manual Instruction manual Service manual Service manual

Contents

TK-33024Notes:• You must install the KCT-53U driver in the computer touse the USB adapter (KCT-53U).• When using the USB adapter (KCT-53U) for the first time,plug the KCT-53U into a USB port on the computer withthe computer power ON.2. When the POWER is switched on, user mode can be en-tered immediately. When the PC sends a command, thetransceiver enters PC mode.When data is read from the transceiver, the red LEDlights.When data is written to by the transceiver, the green LEDlights.Notes :• The data stored in the personal computer must matchModel Name and Model Type when it is written into EE-PROM.• Do not press the [PTT] key during data transmission orreception.3-3. KPG-22/KPG-22A Description(PC programming interface cable : Option)The KPG-22/22A is required to interface the transceiverwith the computer. It has a circuit in its D-sub connector(KPG-22: 25-pin, KPG-22A: 9-pin) case that converts the RS-232C logic level to the TTL level.The KPG-22/22A connects the SP/MIC connector of thetransceiver to the RS-232C serial port of the computer.3-4. KCT-53U Description (USB adapter : Option)The KCT-53U is a cable which connects the KPG-22A to aUSB port on a computer.When using the KCT-53U, install the supplied CD-ROM(with driver software) in the computer. The KCT-53U driverruns under Windows 2000 or XP.3-5. FPU (Programming Software) DescriptionThe FPU is the programming software for the transceiversupplied on a CD-ROM. The software on this disk allows auser to program the transceiver transceivers via Program-ming interface cable (KPG-22/22A).3-6. Programming with PCIf data is transferred to the transceiver from a PC with theFPU, the data for each set can be modified.Data can be programmed into the EEPROM in RS-232Cformat via the SP/MIC jack.In this mode the PTT line operate as TXD and RXD datalines respectively.List of FPU for transceiverModel Type FPUTK-3302 K2,K3,M2 KPG-118D(K)REALIGNMENTPC KPG-22 or KPG-22A orKPG-22A+KCT-53UIllustration is KPG-22FPUTuning cable(E30-3216-05)D-SUB(25-pin)Transceiver Transceiver TransceiverKPG-22PCGrayGray/Black1.5D-XV Lead wire1.5D-XV Shield wire+–+–SPMICD-SUB(9-pin)KPG-22APCUSBKPG-22AKCT-53UPCFig. 14. Wireless Clone Mode4-1. Outline“Wireless Clone Mode” copies the transceiver data toanother transceiver.The dealer can copy the transceiver data to another trans-ceiver even without the use of a personal computer.4-2. ExampleThe transceiver can copy the programming data to one ormore transceivers via RF communication.The clone source and clone target/s must be in wirelessclone mode.