Kenwood TK-390 Service Manual

Also see for TK-390: Brochure & specs Quick guide Instruction manual Service manual Service manual

Contents

11TK-3903. Self ProgrammingWrite mode for frequency data and signalling etc. Mainlyused by the person maintaining the user equipment.3-1. Enter to the self programming modeTurn the power switch on, with the lead wire with plugPF (8 pin) shorted to the E (10 pin) lead (Figure 4), or deleteR466 (SELF, Figure 5) in the TX-RX unit and turn the powerswitch on while pressing the [Side 1] and [Side 2] keys.Note :This mode (self programming mode) cannot be set whenit has been disabled with the FPU.Fig. 4Fig. 5REALIGNMENT11: GREEN (5M)TUBESCREW8: YELLOW (PF SW)2: RED (RX AF OUTPUT)3: BLACK (RX AF OUTPUT)10: BROWN (GND)6: BROWN (MIC GND)5: WHITE (MIC INPUT)7: BLUE (PTT SW) GND → ONShortedWhen enter the self programming mode, "FUNC" appearsafter "SEL" is displayed for half a second.Selecting any of Channel setting, Group setting, Functionsetting, or Clone master with the [Top 1] [Top 2] keys andthen pressing [PTT] sets the Setting mode for that time.Key operations in Self programming mode are as follows.[Selector switch] : Not used[PTT] : Functions as a RUN or Execute key[Top 1] : Use as a Down key[Top 2] : Use as an Up key[Side 1] : Use for select channel steps in Chan-nel setting mode, or switching forQT/DQT.[Side 2] : Use as a cancel key[Orange] : Add or delete frequencies in Channelsetting mode[Toggle] : Flipping this to the right while inChannel setting mode, shifts to MHzsteps.R466X57-5400-10Component sideSELFTP5TP4ELead wire with plug(E30-3287-08)Attach the lead wire with plug[Side 1] + [Side 2] + Power on "SEL""FUNC""GROUP""CHAN""CLONE"[PTT][Top 1][Top 2][Top 1][Top 2][Top 1][Top 2]or[PTT][PTT][PTT]