9TK-61102. How to Enter Each ModeMode OperationUser mode Power onPC mode Turn on the transceiver.Then, set the transceiver to PC mode fromthe menu in KPG-59D.Panel test mode Hold down the [MON] key, turn the radiopower on.Main programming Hold down the [A] key, turn the radiomode power on.REALIGNMENT3. Clone Mode1. Turn the master side transceiver power on with the[SCN] key held down. The master side transceiver dis-plays “CLONE”.2. Set the power switch on the slave side transceiver toON.3. Connect the cloning cable (E30-3382-05) between themaster side transceiver (source) and slave side trans-ceiver (clone).4. Press the [SCN] key on the master side transceiver tostart cloning.5. The TX LED on the master side transceiver flashes whencloning starts and an “END” message appears whencloning ends.6. The BUSY LED on the slave side transceiver flashes.7. When a problem occurs during cloning, an “ERROR”message appears on the slave side transceiver.8. Pressing the [SCN] key sets clone mode again.4-3. Programming1. Set the transceiver to Main Programming Mode.2. Connect the KPG-46 to the transceiver.3. Start up the programming software (KPG-59D), select“firmware program” in the “Program” item, and pressthe Return key on the personal computer. This starts upthe firmware programmer.4. The top screen is displayed. Press any key to advanceto the next screen.5. Set the communications speed (normally, 115,200bps)and communications port in the Setup item.6. Set the firmware to be updated by File select.7. Held down the [A] key. Turn the transceiver power on.Until the display change to “PROG1152”8. Check the connection between the transceiver and thepersonal computer, and make sure that the transceiveris in the Main Programming Mode.9. Press F10 on the personal computer. A window openson the display to indicate progress of writing. When thetransceiver starts to receive data, “PG” is appeared on2 digit sub display.10. If writing ends successfully, the TX LED on the trans-ceiver lights and the checksum is displayed.11. If you want to continue programming other transceiv-ers, repeat steps 5 to 8.Notes :• To start the Firmware Programmer from KPG-59D, theFpro path must be set up by KPG-59D setup.• This mode cannot be entered if the Main Programmingmode is set to Disable in the Programming software(KPG-59D).4-4. Function1. If you press the [SCN] key while “PROG1152” is dis-played, the checksum is displayed. If you press the [C]key while the checksum is displayed, “PROG1152” isredisplayed.2. A transmission speed can be selected by pressing the [C]key while “PROG1152” is displayed.115200bps : PROG115219200bps : PROG 19238400bps : PROG 38457600bps : PROG 576Note :Normally, write in the high-speed mode.5. Panel Test ModeSetting method refer to ADJUSTMENT.[SCN][SCN][SCN] STARTCLONE END4. Main Programming Mode4-1. PrefaceFlash memory is mounted on the transceiver. This al-lows the transceiver to be upgraded when new features arereleased in the future. (For details on how to obtain the firm-ware, contact Customer Service.)4-2. Connection ProcedureConnect the transceiver to the personal computer (IBMPC or compatible) with the interface cable (KPG-46). (Con-nection is the same as in the PC Mode.)