Kenwood TK-7360 Instruction Manual

Also see for TK-7360: Brochure & specs Specifications Instruction manual Service manual Instruction manual

Contents

trAnSmitting/ receiVing1 Select your desired zone and channel.2 Press the microphone PTT switch and speak into the microphone to transmit.Release the PTT switch to receive.• For best sound quality at the receiving station, hold the microphone approximately.5 inches (3 ~ 4 cm) from your mouth.SCANScan monitors for signals on the transceiver channels. While scanning, thetransceiver checks for a signal on each channel and only stops if a matchingsignal is present. There are two types of scans available.• Single Scan: Monitors the channels of only the currently selected zone. If set up toscan the Priority channel, it will be scanned even if it is not in the selected zone.• Multi Scan: Monitors the channels of every zone.To start/stop scanning, press the key programmed as Scan.• “SCAN” and the icon appear on the display during scan.• When a signal is detected, scan pauses at that channel. The transceiver will remain onthe busy channel until the signal is no longer present, at which time scan resumes.Note: To use Scan, there must be at least 2 channels added to the scan sequence.chAnnel recAllDuring scan, you can recall the last zone and channel/group ID on which youmade a call by pressing the key programmed as CH/GID Recall. Scan willremain paused on the Recall channel until you press the key again.priority ScAnIf a Priority channel has been programmed, the transceiver will automaticallychange to the Priority channel when a call is received on that channel, even if acall is being received on a normal channel.• The icon appears on the display when the Priority channel is selected.temporAry chAnnel lockoutDuring scan, you can temporarily remove specific channels from the scanningsequence by pressing the key programmed as Scan Delete/Add while Scan ispaused at the undesired channel. To temporarily remove a zone, press and holdScan Delete/Add while Scan is paused at a channel in the undesired zone.• The channel/zone is no longer scanned. However, when scanning is ended andrestarted, the Scan settings return to normal.