2n Transmitting1 Select your desired zone and channel.2 Press the key programmed as Selcall or Selcall + Status.3 Press / (if the key assignment list selection is configured as “Enabled”)or /C> to select the ID of the station you want to call.• You can also enter the station ID directly by using the keypad.4 Press the PTT switch and begin your conversation.• You can also press n to page the ID, rather than talking.n ReceivingIf enabled by your dealer, an alert tone will sound and the LED will blink whena Selcall has been received. To respond to the call, press the PTT switch andspeak into the microphone.n Identification CodesAn ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.Each transceiver must have its own Fleet and ID number.Note: The ID range may be limited by programming.pAging cAll1 Select your desired zone and channel.2 Press the key programmed as Paging Call to transmit your PTT List ID, torequest a call.StAtuS meSSAgeStatus messages are 2-digit codes ranging from 0 to (0 ~ are reservedfor special messages).A maximum of 5 received messages can be stored in the stack memory of yourtransceiver and can be reviewed after reception. The icon appears when amessage is stored in the stack memory.n TransmittingIf programmed by your dealer, you can press the Call 1 ~ Call 3 keys toquickly send preprogrammed status messages. You can also manually sendstatus messages.1 Select your desired zone and channel.2 Press the key programmed as Status or Selcall + Status.• When pressing the Status key, the target Fleet/ ID is fixed and cannot beselected. Skip to step 5 to continue.3 In Selcall mode, press / (if the key assignment list selection is configuredas “Enabled”) or /C> to select the ID of the station you want to call.• You can also enter the station ID directly by using the keypad.