3TK-790/(B)/H(B)PRE-INSTALLATION CONSIDERATIONS1. UNPACKINGUnpack the radio from its shipping container and checkfor accessory items. If any item is missing, please contactKENWOOD immediately.2. LICENSING REQUIREMENTSFederal regulations require a station license for each ra-dio installation (mobile or base) be obtained by the equip-ment owner. The licensee is responsible for ensuring trans-mitter power, frequency, and deviation are within the limitspermitted by the station license.Transmitter adjustments may be performed only by a li-censed technician holding an FCC first, second or generalclass commercial radiotelephone operator’s license. Thereis no license required to install or operate the radio.3. PRE-INSTALLATION CHECKOUT3-1. IntroductionEach radio is adjusted and tested before shipment. How-ever, it is recommended that receiver and transmitter opera-tion be checked for proper operation before installation.3-2. TestingThe radio should be tested complete with all cabling andaccessories as they will be connected in the final installa-tion. Transmitter frequency, deviation, and power outputshould be checked, as should receiver sensitivity, squelchoperation, and audio output. QT equipment operationshould be verified.4. PLANNING THE INSTALLATION4-1. GeneralInspect the vehicle and determine how and where theradio antenna and accessories will be mounted.Plan cable runs for protection against pinching or crush-ing wiring, and radio installation to prevent overheating.4-2. AntennaThe favored location for an antenna is in the center of alarge, flat conductive area, usually at the roof center. Thetrunk lid is preferred, bond the trunk lid and vehicle chassisusing ground straps to ensure the lid is at chassis ground.4-3. RadioThe universal mount bracket allows the radio to bemounted in a variety of ways. Be sure the mounting surfaceis adequate to support the radio’s weight. Allow sufficientspace around the radio for air cooling. Position the radioclose enough to the vehicle operator to permit easy accessto the controls when driving.4-4. DC Power and wiring1. This radio may be installed in negative ground electricalsystems only. Reverse polarity will cause the cable fuseto blow. Check the vehicle ground polarity before installa-tion to prevent wasted time and effort.2. Connect the positive power lead directly to the vehiclebattery positive terminal. Connecting the Positive lead toany other positive voltage source in the vehicle is not rec-ommended.3. The cable provided with the radio is sufficient to handlethe maximum radio current demand. If the cable must beextended, be sure the additional wire is sufficient for thecurrent to be carried and length of the added lead.5. INSTALLATION PLANNING – CONTROL STATIONS5-1. Antenna systemControl station. The antenna system selection dependson many factors and is beyond the scope of this manual.Your KENWOOD dealer can help you select an antenna sys-tem that will best serve your particular needs.5-2. Radio locationSelect a convenient location for your control station radiowhich is as close as practical to the antenna cable entrypoint. Secondly, use your system’s power supply (whichsupplies the voltage and current required for your system).Make sure sufficient air can flow around the radio andpower supply to allow adequate cooling.SERVICEThis radio is designed for easy servicing. Refer to theschematic diagrams, printed circuit board views, and align-ment procedures contained in this manual.GENERAL