Kenwood TK-885 Service Manual

Also see for TK-885: Instruction manual Service manual

Contents

6TK-885 REALIGNMENT / INSTALLATIONNotes :• This mode cannot be entered if the Firmware program-ming mode is set to Disable in the Programming soft-ware (KPG-62D).• When programming the firmware, it is recommend tocopy the data from the floppy disk to your hard disk be-fore update the radio firmware.Directly copying from the floppy disk to the radio may notwork because the access speed is too slow.6-4. Function1. If you press the [] switch while “PROG 57600” is dis-played, the version is displayed. If you press the []switch again while the version is displayed, “PROG57600” is redisplayed.2. If you press the [D ] switch while “PROG 57600” isdisplayed, the display changes to “PROG 19200” to indi-cate that the write speed is low speed (19200 bps). Ifyou press the [D ] switch again while “PROG 19200” isdisplayed, the display changes to “PROG 38400”, andthe write speed becomes the middle speed (38400 bps).If you press the [D ] switch again while “PROG 38400”is displayed, the display returns to “PROG 57600”.3. If you press the [D ] switch while the version is dis-played, the checksum is displayed. If you press the[D ] switch again while the checksum is displayed, theversion is redisplayed.Note :Normally, write in the high-speed mode.3 45678 9INSTALLATION1. Accessory Connection Cable(KCT-19 : Option)The KCT-19 is an accessory connection cable for con-necting external equipment. The connector has 15 pins andthe necessary signal lines are selected for use.1-1. Installing the KCT-19 in the transceiver1. Remove the upper and lower half of the transceiver case,and lift the DC cord bushing ( ) from the chassis.2. Remove the pad as shown in Figure 1 ( ).3. Insert the KCT-19 cable ( ) into the chassis ( ).The wire harness band ( ) must be inside the chassis.4. Replace the DC cord bushing ( ).5. Connect the KCT-19 to the TX-RX unit (A/2) as shown inFigure 2 ( ).6. Connect the KCT-19 to the external accessory by insert-ing the crimp terminal ( ) into the square plug ( ),both of which are supplied with the KCT-19.12Fig. 112Fig. 2131315Crimp terminal(E23-0613-05)BECBDCN6CN2CN4CN3DEBCAContactSquare plug(E09-1571-05)3467895CN1