2MObIlE INSTAllATIONn TX/ RX unit InstallationSelect a safe, convenient location inside your vehicle that will minimize dangerto your passengers and yourself while the vehicle is in motion. Considerinstalling the transceiver under the dash in front of the passenger seat so thatknees or legs will not strike the radio during sudden braking of your vehicle.Try to a pick well-ventilated location that is shielded from direct sunlight.Note: You may experience interference on your GPS receiver when using in or around 438.8MHz (A band) and/or 443.8 MHz (B band). To eliminate the interference, ensure that thetransceiver is installed at a location separate from your GPS receiver.1 Install the mounting bracket in the vehicle using the supplied self-tappingscrews and flat washers (4 of each are supplied).• The bracket can be mounted with the bracket opening facing down, for under dashmounting, or facing up.• The bracket must be installed so that the 3 screw slots on the edge of each bracketside are facing the back.2 Position the transceiver, then insert and tighten the supplied hexagonSEMS screws and flat washers (4 of each are supplied, 2 for each side ofthe bracket).• Ensure that all hardware is tightened, to prevent vehicle vibration fromloosening the bracket or TX/ RX unit.• Set an appropriate angle for the TX/ RX unit, using the 3 screw slots onthe rear edge of each bracket side.Self-tapping screw(5 x 6 mm)Flat washerSEMS screw (M4 x 0 mm)