Kenwood TM-D710GE Instruction Manual

Also see for TM-D710GA: Instruction manual Quick start guide

WIRELESS OPERATION (TM-D710GA ONLY)If you also have a compatible KENWOOD handy transceiver, you may use it as a remote control for this mobile transceiver. You willcontrol one band on the mobile while sending DTMF tones to the other band from the handheld. This function is useful, for example,when you want to control the mobile from a location outside your vehicle.Note:◆ As a remote control, you can also use a handy transceiver which does not have a remote control function but a DTMF function. However, you must manually sendDTMF tones for control code strings. Skip steps 1 and 3 in “PREPARATION”.◆ The FCC rules permit you to send control codes only on the 440 MHz band.PREPARATIONLet us assume band A (VHF) of the mobile transceiver will becontrolled.On the handy transceiver:1 Program a 3-digit secret number.• For the programming method, see the instruction manual for thehandheld.2 Select the transmit frequency on the UHF band.3 Make the handheld enter Remote Control mode.• For the method, see the instruction manual for the handheld. Ifnot described, consult your dealer.On the mobile transceiver:4 Enter Menu mode and access Menu 923.5 Set the ID code to the same secret number you set on thehandy transceiver.6 Select the receive frequency on band B (UHF).• Match this frequency with the transmit frequency on thehandheld.7 Select band A (VHF) as the TX band or Control band.8 To cause the mobile to send a control acknowledgment to thehandheld, enter Menu 924 and set it to ON.• DTMF tones which represent the secret number will be used asan acknowledgment.9 Turn the transceiver power OFF.10 Press [REV] + Power ON to enter Remote Control mode.• The (blink) and icons appear on the display.• To exit Remote Control operation, turn the transceiver powerOFF, then press [REV] + Power ON again.CONTROL OPERATIONWhile in Remote Control mode, the DTMF keys of the handheldwill function as shown in the table below. Each time you pressthe desired key, the handheld will automatically enter transmitmode and send the corresponding command to the mobile.Note: If using a handheld without a remote control function, manually send“AXXX#YA#” where “XXX” is a 3-digit secret number and “Y” is a single-digitcontrol command. If you do not add ”A#” to the end, you can skip sending“AXXX#” next time; however, the mobile may be accidentally controlled by otherstations.Operation DTMFCommandAccess your mobile via the remote unit(where *** is your 3-digit secret number) A *** #End access of your mobile via theremote unit A #DCS ON 1Tone ON 2CTCSS ON 3DCS OFF (all signalling OFF) 4Tone OFF (all signalling OFF) 5CTCSS OFF (all signalling OFF) 6Call mode ON 7VFO mode ON 8Memory mode ON 9Transmit power (press to toggle betweenHigh, Medium, and Low) 0Frequency (in VFO mode) or Memorychannel (in Memory mode) direct entry A XXXXXXXDCS code (when DCS is ON), Tonefrequency (when Tone is ON), or CTCSSfrequency (when CTCSS is ON) setupB XXX(DCS code)BA XX (Tone/CTCSSfrequencyRepeater (Cross-band or Locked-band)ON CRepeater OFF DStep the frequency or Memory channeldownStep the frequency or Memory channelup #WIRELESS OP-1