Kenwood TS-2000 Instruction Manual

Also see for TS-2000: Instruction manual Service manual Specifications Service manual Service manual

Contents

Kenwood TS-2000 Instruction Manual Manual pdf 106 page image

17 INSTALLING OPTIONS98MB-430 MOBILE BRACKETWhen installing the MB-430, attach the suppliedplastic spacers (G11-2698-XX) to the transceiver inadvance. This is necessary to protect theTS-2000(X)/ TS-B2000 transceiver from scratches.Once the bracket is installed onto the vehicle,prepare the transceiver by loosely screwing in therear screws. Hook those screws onto the rear guiderail of the mounting bracket then adjust thetransceiver to your desired angle before tighteningthe screws. Insert and tighten the front screws tosecure the transceiver in place.To remove the transceiver from the bracket, firstremove the front screws, then loosen the rear screwsslightly and pull the transceiver forward to unlatch itfrom the bracket.Do not install the transceiver so that it is vertically on its side.RC-2000 REMOTE PANELPlug the modular cable from the RC-2000 into thePANEL connector on the TS-2000(X)/ TS-B2000 rearpanel. Access Menu Nos. 58 ~ 60 to adjust the panelconfiguration if necessary.TS-2000/ TS-2000XTS-B2000Rear screw Rear screwFront screwFront screwMake sure the tab faces outG11-2698-XX