Kenwood TS-2000 Instruction Manual

Also see for TS-2000: Instruction manual Service manual Specifications Service manual Service manual

Contents

Kenwood TS-2000 Instruction Manual Manual pdf 22 page image

144 GETTING ACQUAINTEDDISPLAYFILTERS13579204060dBPWR102550100W%ALC612 4 10 93 511 13 1578 12 14 16q METERWhile receiving, serves as an S-meter to measureand display the received signal strength. It alsodisplays the filter width. While transmitting, serves asa power meter plus an ALC meter, an SWR meter, ora Speech Processor compression meter. The PeakHold function holds each reading for approximatelyhalf a second.Note: SWR meter works only for the HF and 50 MHz bands.wAppears while the internal antenna tuner {page 72} oran external antenna tuner is in-line for the HF/ 50 MHzband reception.e ATAppears while the internal antenna tuner {page 72} oran external antenna tuner is in-line for the HF/ 50 MHzband transmission.rAppears while HF RX ANT {page 76} connector isenabled to receive HF band signals. You cannottransmit the signals though this connector.tEither “ ” or “ ” appears, depending onwhether the Antenna 1 connector or the Antenna 2connector is selected for the HF/ 50 MHz band{page 72}.y MHzAppears when the MHz Up/ Down mode using theMULTI/ CH control is switched ON {page 37}.u ALTAppears when ALT (Auto Lock Tuning) is activated forthe 1.2 GHz (FM) band {page 72}.iAppears while Memory Recall or Memory Scroll isbeing used {page 59}.oShows the memory channel number for the maintransceiver. If you select a channel over 99, aleading digit (1 or 2) appears (the memory numberranges from 00 to 299). It also shows the QuickMemory number location (the Quick Memory numberranges from “0_” to “9_”).!0 AUTOAppears when Auto mode selection is activated{page 73}.!1Appears when the main transceiver is selected for thetransmission band.!2Appears when the main transceiver’s functions canbe controlled using the front panel keys.!3 ATTAppears when the main transceiver’s receiverattenuator (approx. 12 dB) is ON {pages 57, 73}.!4 TNCAppears when the internal TNC is assigned to themain transceiver {page 49}.!5 PREAppears when the receiver pre-amplifier of the maintransceiver is ON {page 57}.!6 + =“+” or “–” appears, indicating which offset direction isselected for the main transceiver. “=” appears whenthe –7.6 MHz (430 MHz) or –6.0 MHz (1.2 GHz)offset is selected (all E-types only) {page 32}.