40Chapter Two : Setting Up the Remote Control UnitRemote SetupIf a device cannot be remote controlledwith any code in the list, or to add remotecontrol target functions...This Remote Control unit incorporates an advanced Learnfunction which makes it possible to program remote con-trol signals used by another remote control unit in itself. Ifthe setup code of a connected device is not contained inthe Remote Control unit memory, program the code inRemote Control unit using this function.This function can also be used to change a setup code oradd extended function to the remote control target.• Up to five extended functions per device can be pro-grammed additionally in this Remote Control unit us-ing “Extend1” to “Extend5” displayed on the LCD screen.• The remote control signals transmitted by this RemoteControl unit keys can be changed. The signals from thekeys painted black in the following figure can be modi-fied.2WAY LCD REMOTE CONTROL UNITMUSIC MOVIE TVCONFIRM/SHIFTAV.POWER SYS.POWERTITLE/GUIDE MENUMACROF.SHIFT+-+-REC LEARNSOUNDTUNINGBANDLISTEN M.INPUT MODE STATUSDIMMERSUB.W.MUTEENTERAUTO/MONOREPEATREC MODERANDOMBACK LIGHTINPUT SEL.TV SELECT DISPLAY SELECTAUDIO THEME FAVORITEINFO. EXIT LAST CHANNELCH.CH. VOL.VOL.RETURN/PAGE OSD/PAGE2. Press the LEARN key.3. Select one of Extend1 to Extend5 using the orkey, then press the Enter key (LCD function key 2).Press the Exit key (LCD function key 2) to exit from theoperation.Press the Clr (clear) key if you want to clear the previouslyprogrammed remote control signal and reset to the factoryshipment condition. (Cleared is displayed.)4. To program remote control signal, place the two unitsopposite to each as shown below. On the Remote Con-trol unit of the selected device, press the key transmit-ting the desired remote control signal. Complete is dis-played when the remote control signal has been pro-grammed in this Remote Control unit.RF REMOTE CONTROL UNITRC-R09102WAY LCD REMOTE CONTROL UNIT+-+-1 2 34 5 67 8 910 11 12+10 0 +100/8/711• “Error” is displayed when it failed.5. To program other remote control signals, repeat steps 1to 4 for each.Video1DVDMenuExtend1Extend2Extend3Home EnterWaitingExtend1Clr ExitCompleteExtend1To program new functions in Extend1 to Extend5:1. Select the controlled device (CD, DVD, etc.) by pressingthe Music, Movie or TV key.4inches(10cm)ErrorExtend1