Kenwood VR-905 Instruction Manual

Also see for KRF-V5090D: Instruction manual Service manual

4 ENFor the U.S.A.Note to CATV system installerThis reminder is provided to call the CATV system installer's attentionto Article 820-40 of the NEC that provides guidelines for propergrounding and, in particular, specifies that the cable ground shall beconnected to the grounding system of the building, as close to thepoint of cable entry as practical.FCC WARNINGThis equipment may generate or use radio frequency energy. Changesor modifications to this equipment may cause harmful interferenceunless the modifications are expressly approved in the instructionmanual. The user could lose the authority to operate this equipmentif an unauthorized change or modification is made.NOTE:This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment maycause harmful interference to radio communications, if it is notinstalled and used in accordance with the instructions. However,there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:– – Reorient or relocate the receiving antenna.– – Increase the separation between the equipment and this model.– – Connect the equipment into an outlet on a circuit different fromthat to which this model is connected.– – Consult the dealer or an experienced radio / TV technician forhelp.For the U.S.A.As an E NERGY S TAR® Partner, KenwoodCorporation has determined that this productmeets the E NERGY S TAR® guidelines forenergy efficiency.This product can save energy.Saving energy reduces air pollution and lowersutility bills.Before applying the powerPreparing the remote controlLoading the batteries1 Remove the cover. 2 Insert the batteries.3 Close the cover.• Insert two AAA-size (R03) batteries as indicated by the polaritymarkings.6 mRECEIVEROperating range(Approx.) Remote sensorInfrared ray systemOperationWhen the STANDBY indicator is lit, the power turns ON when you pressthe RECEIVER key on the remote control. When the power comesON, press the key you want to operate.• When pressing more than one remote control key successively,press the keys securely by leaving an interval of 1 second or morebetween keys.Notes1. The supplied batteries may have shorter lives than ordinary batteriesdue to use during operation checks.2. When the remote-controllable distance gets shorter than before,replace both batteries with new ones.3. Placing the remote sensor in direct sunlight, or in direct light from ahigh frequency fluorescent lamp may cause a malfunction.In such a case, change the location of the system installation toprevent malfunction.