Kenwood XD-552 Instruction Manual

Contents

Kenwood XD-552 Instruction Manual Manual pdf 16 page image

XD-SERIES (En)16Preparation sectionOperation of remote control unitLoading batteries1 Remove the cover. 3 Close the cover.÷ Insert two R6 (“AA”-size) batteriesfollowing the polarity indications.2 Insert batteries.OperationPlug the power cord into the mains power outlet andpress the on/standby ( POWER) key of the remotecontrol unit to turn power ON. After the power has beenturned ON, press the desired key.To turn power off, press the on/standby( POWER) keyagain.The power mode enters the STANDBY mode in whichthe “STANDBY” indicator lights up. (The “TIMER” in-dicator also lights in this mode if a timer program hasbeen activated.)÷ When pressing more than one remote control keyssuccessively, press the keys securely by leaving aninterval of 1 second or more between keys.1.The provided batteries are intended for use in operation checking, and their service life may be short.2.When the remote controllable distance becomes short, replace both of the batteries with new ones.3.If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remotesensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.Operating range(approx.)Remote sensor21NotesNotesCHANNELSPACE freq.Area12USA, Canada and SouthAmerican countriesOther countriesFM : 100 kHzAM : 10 kHzFM : 50 kHzAM : 9 kHzThe space between radio channels has been set to theone that prevails in the area to which the system isshipped. However, if the current channel space settingdoes not match the setting in the area where the sys-tem is to be used, for instance when you move fromarea 1 or area 2 shown in the following table or viceversa, proper reception of AM/FM (MW/FM) broad-casts cannot be expected. In this case, change the chan-nel space setting in accordance with your area by re-ferring to the following table.CHANNEL SPACE setting(Except for the U.S.A., Canada, U.K., Europe, Australia and Russia)1 Select the TUNER input.2 While holding the SELECT key depressed, turnthe SOUND CONTROL jog dial to select thesystem mode.ENTERF 0M 1 0 0 / A M 1 F 9M 5 0 / A MSELECT30˚6m30 ˚÷ The “AM” display is variable depending on the model(country or area), and “MW” may be displayed insome areas.1 “FM100/AM10 kHz” STEP,2 “FM 50 /AM 9 kHz” STEP,3 Establish the selection.SOUND CONTROL