Kenwood XD-552 Instruction Manual

Contents

Kenwood XD-552 Instruction Manual Manual pdf 29 page image

XD-SERIES (En)29Basic section4. Select the source to be recorded.1 TUNER (Radio)2 CD3 TAPE (This source cannot be recorded.)4 MD/DVD (External input)( Input level adjustment u)The input source component tobe recorded should be displayed.÷ If a disc has already been loadedwhen the CD input is selected, itwill starts to play automatically. Inthis case, press the stop (&) key tostop it.Select an input source otherthan “TAPE”.1 Start recording.2 Play (or tune) the input source to be recorded.5. Start recording.÷ Even if deck A is selected, it isautomatically switched to deck Bat the start of recording.÷ Recording stops automaticallywhen the tape side(s) to be re-corded have been fully recorded.÷ Press the stop (&) key of the cas-sette deck unit to stop recording.C 2D 0 1 1 : 1LightsINPUT44REC/ARM 55XD-4....seriesXD-5....seriesLet's recordThe DOLBY NR system minimizes the hiss noise heardwhen playing tape. When playing a tape prerecordedwith DOLBY NR ON, be sure to set the DOLBY NR ONfor playback.Selection of DOLBY NR (Noise Reduction)(Main unit only) (XD-5....series only)Lit when “DOLBY NR” is ON.DOLBY NRTo pause recording (Main unit only)÷ Pressing the key pauses recording after leaving anon-recorded space of about 4 seconds.÷ If the key is pressed again in less than 4 seconds after ithas been pressed, recording resumes from that instant.Each press switches the modes as follows.1 “ ” .... Recording stops after having re-corded both sides of tape.2 “ ” ... Recording stops after having re-corded both sides of tape.3 “ ” ..... Recording stops after having re-corded one side of tape.Selection of the reverse mode (Main unit only)REC/ARMREV. MODELights÷ Select the DOLBY NR mode according to the recordingcondition of the tape.Each press switches the modes as follows.1 “1 NR” ON .... DOLBY NR is used.2 “1 NR” OFF ... DOLBY NR is not used.Dolby noise reduction manufactured under license fromDolby Laboratories.“DOLBY” and the double-D symbol are trademarks ofDolby Laboratories.XD-4....seriesXD-5....series÷ When the “2” transport direction indicator is lit,recording always stops after having recorded oneside of tape.