Kenwood XXV-01D Instruction Manual

Also see for XXV-01D: Instruction manual Service manual

16 | EnglishGeneral featuresBypass ControlTemorarily bypassing DSP (Digital SignalProcessor) System.1 Select the source to adjustPress the [SRC] button.2 Show the Multi-function displayPress the [NEXT] button repeatedly until"DSP" appears.Refer to (page9).3 Enter Bypass Control modeTurn the [VOL] knob to select "DSP".Press the [VOL] knob.• When "2ZONE" of

cannot select "DSP".4 Set up BypassPress the [VOL] knob."Bypass": There is no effect by DSP."Through": There is an effect by DSP.• When the mode is set to "Bypass", DSP System cannotbe adjusted.• When the mode is set to "Bypass", ODD D/A System isnot effective.Memory modeStoring the values of Sound Control in memory.1 Setup Sound ControlRefer to the following operations to setup theSound Control.-

- (page 12)- (page 13)- (page 14)2 Select the Preset Memory itemTurn the [VOL] knob to select "Preset".Press the [VOL] knob.3 Enter Memory modeTurn the [VOL] knob to select "Memory".Press the [VOL] knob.4 Put in the memoryTurn the [VOL] knob to select "Memory1" or"Memory2".Press the [VOL] knob for at least 2 seconds.The "MEMORY" display blinks 1 time.5 Exit Memory modeTurn the [VOL] knob to select "Return".Press the [VOL] knob.• "Memory1": When you press the Reset, all thesources will be the setting value which isregistered.• The following items cannot be registered.Rear Volume, Balance, Fader, Position Setting, SystemQ SettingMemory Recall modeRecall the value in the memory by the memorymode.1 Select the source to adjustPress the [SRC] button.2 Show the Multi-function displayPress the [NEXT] button repeatedly until"S.F.C" appears.Refer to (page9).3 Select the key function which contains theitem you wish to recallTurn the [VOL] knob to select "S.F.C"/ "S.M.S"/"EQ".Press the [VOL] knob.4 Select the Preset Memory itemTurn the [VOL] knob to select "Preset".Press the [VOL] knob.5 Enter recall modeTurn the [VOL] knob to select "Recall".Press the [VOL] knob.6 Select the recall itemTurn the [VOL] knob to select "Recall1" or"Recall2".Press the [VOL] knob for at least 2 seconds.The "RECALL" display blinks 1 time.