English | 27Select the Font ColorPush the Control knob to [4] or [¢].7 Exit display control modePress the [6] ("RTN") button.Function of the KDC-X889/KDC-MP828/KDC-MP7028/KDC-MP728/KDC-X789 Display Type EG-Analyzer display SwitchingSwitches G-Analyzer display when the Displaytype is set to "Display Type E". (G: gravity)• Before switching G-Analyzer display, set> (page 44) and (page44) are required to be setup.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "DISP" isdisplayed above the [6] (KDC-X889/MP828)/[2](KDC-MP7028/MP728/X789) button.Refer to (page 9).2 Enter display control modePress the [6]/[2] ("DISP") button.3 Select the display modePress the [1] ("MODE") button.4 Select the display TypePush the Control knob to [4] or [¢].Select the "Display Type E" display.5 Enter G-Analyzer display select modePress the [3] ("GMENU") button.6 Select the G-Analyzer displayPush the Control knob to [4] or [¢].G-Force Sensor displayG- Graphic displayG-Meter display(Graphic)G-Meter display(Text)PointTimeG-Counter display• G-Graphic displayDisplays the condition of G on horizontal direction(e.g; when turning the curve) by the graphic.• G-Meter display (Graphic)Displays the maximum value of acceleration G, rightdirection G, and left direction G by the numericalvalue.• G-Meter display (Text)The maximum value of acceleration G, right directionG, and left direction G is displayed by the numericalvalue. The value of G is only the reference so it isdiffered from the actual value.• G-Counter displayAdds the point of the acceleration level. The pointis determined after a lapse of 1 hr drive or at poweroff (ex; ACC Off ), and then it will be displayed by thegraph. Furthermore, it displays the average of the pastdata by the line. (The scale of graph is determinedalong with the largest point among the past 10 data.)• The value of G-Meter display and G-Counter displaycan be reset by (page 44).7 Exit display control modePress the [6] ("RTN") button.TEL MuteThe audio system automatically mutes when acall comes in.When a call comes in"CALL" is displayed.The audio system pauses.Listening to the audio during a callPress the [SRC] button.The "CALL" display disappears and the audiosystem comes back ON.When the call endsHang up the phone.The "CALL" display disappears and the audiosystem comes back ON.
