Kenwood eXcelon KDC-X915 Instruction Manual

Also see for KDC-9015: Service manual

The 4 button moves the cursor to the left, and the ¢button to the right.You can also move the cursor left or right by pressing the 4or ¢ buttons, respectively, on the remote.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the FM or AM button to display the desired character.Characters that can be displayed are as follows.Direct Alphabet Input (KDC-X915/X815 only)Direct input can be made of letters (alphabetical) with the letterentry buttons on the remote.Example: Use the following table to enter the name "DANCE".Continue steps 3 and 4 until all the characters are chosen forthe name.You can enter up to 8 characters for each name.Assigning NamesPress the NAME.S button on the unit or the OK button on the6NOTE5Button to press # Times pressedCharacter#3 11#2#6 2#2 3#3 2“D”“A”“N”“C”“E”NOTEAlphabet (upper case): A ~ ZAlphabet (lower case): a ~ zNumerals and symbols: 0~9 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä êë î ï ô ö û ü ñ ç © Æ › fi4You can assign names to radio stations with the Station PresetMemory. Up to 32 FM stations and 16 AM stations can beassigned names.Adjust the frequency to the station whose name you want toenter.When full-screen display has been selected for the display modeand the upper part display of the vertical division display is theprogram service name or radio text, the station name presetfunction cannot be used.Press the NAME.S button for at least two seconds."NAME SET" is displayed once the station name preset mode isentered.The cursor will blink in the position where letters are entered.Press either the 4 or ¢ button to move the cursor to thedesired position.32NOTE1Station Name Preset (SNPS)You can automatically store all the receivable frequencies inthe band currently being listened to, and then recall them withthe touch of a button later. This function is especially usefulwhen you are travelling and do not know what stations areavailable. Up to six frequencies can be stored this way.Select the band for auto memory entry.Press the AME button for at least two seconds to start automemory entry.The numbers of the preset station buttons are shown in order.When all the stations in a certain band are stored in the presetmemory, the auto memory entry stops. The tuner then playsthe last station received.Recalling a Preset Station:Press the preset station button (#1-6) for the desired station.The number of the recalled station is displayed.21Auto Memory EntryTuner features— 18 —English