Service and Maintenance 8Recommended Test EquipmentE364xA User’s and Service Guide 189Recommended Test EquipmentTable 8- 4 describes the test equipment recommended for theperformance verification and adjustment procedures. If theexact instrument is not available, use the accuracyrequirements shown to select substitute calibrationstandards. If you use equipment other than therecommended equipment shown in Table 8- 4, you mustrecalculate the measurement uncertainties for the actualequipment used.Table 8-4 Recommended test equipmentEquipment Requirements Recommended model Test functionGPIB controller Full GPIB or RS-232 capabilities Keysight 82357B interfacecard or equivalentProgramming and readbackaccuracyOscilloscope 100 MHz with 20 MHz bandwidth Keysight DSO5034A orequivalentDisplay transient responseand ripple and noisewaveformRms voltmeter 20 Hz to 20 MHz Keysight 54602Boscilloscope or R&S URE3rms voltmeterMeasure rms ripple and noiseCable (BNC-to-BNC) 50 Ω, 9 inch (23 cm) Keysight 10502A or 10503A ifthe 10502A is not availableMeasure rms ripple and noise(CV PARD, CC PARD)BNC (female) bulkheadreceptacle• Isolated ground• Nominal impedance: 50 ΩPomona Model 5148 Measure rms ripple and noise(CV PARD, CC PARD)Split ferrites For use with round cable Steward Co. 28A2029-0A0 Noise coupling reductionDigital voltmeter • Resolution: 0.1 mV• Accuracy: 0.01%Keysight 34401A Measure DC voltagesElectronic load • Voltage range: 240 Vdc• Current range: 10 Adc• Open and short switches• Transient on/offKeysight 6060B or equivalent Measure load and lineregulations and transientresponse time
