Keysight Technologies InfiniiVision 3000 X Series User Manual

Contents

204 Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide13 CursorsYou can press the X Units softkey to select:• Seconds (s).• Hz (1/s).• Phase (°) — when selected, use the Use X Cursors softkey to set the current X1location as 0 degrees and the current X2 location as 360 degrees.• Ratio (%) — when selected, use the Use X Cursors softkey to set the current X1location as 0% and the current X2 location as 100%.You can press the Y Units softkey to select:• Base — the same units used for the source waveform.• Ratio (%) — when selected, use the Use Y Cursors softkey to set the current Y1location as 0% and the current Y2 location as 100%.For phase or ratio units, once the 0 and 360 degree or 0 and 100% locations areset, adjusting cursors will display measurements relative to the set locations.7 Adjust the selected cursor(s) by turning the Cursors knob.