47Operating Instructions SEG6 Maintenance6.4 Cleaning the device from the outside6.4.1 Removing dirt from the outsideTo clean the pull-rope emergency stop switch from out-side, proceed as follows:1. Before starting work, isolate the system from thepower supply. Secure the system from beingswitched on again. Cover any adjacent, live parts sothat they cannot be touched.2. Remove the pull-rope from trigger lever (1). Observethe instructions in the documentation on the pull-rope system.Danger of death if the safety instructions arenot observed!Always observe the safety measures and general in-structions described in Chapter 1: „Safety“, page 7.Risk of death from electrical shock!Only an electrician may work on the device.Before starting work, isolate the system from the powersupply. Secure the system from being switched onagain. Cover any adjacent, live parts so that they can-not be touched.!Warning - risk of injuries when the releaseline is disconnected!The release line is under spring tension. Carefully dis-connect the release line from the release lever so thatthe release line cannot spring back uncontrollably. Ob-serve the documentation for the release line system.!Fig. 6-3: Cleaning2 1