LaCie 12big Rack Fibre 8 Getting StartedUser Manual page 352.4.3.2. Installing the RAID Controller ModuleThe RAID Controller Modules are installed with the primary (C0) inthe upper bay and the secondary (C1) in the lower bay.IMPORTANT INFO: Before installing the RAID Controllers, makea note of each controller’s MAC address listed on the label on thetop of the canister. The MAC address will be used when setting upthe Embedded StorView modules at the first startup.1. Check for damage, especially to the interface connector.CAUTION: Handle the module carefully and avoid damaging theconnector pins. Do not install the module if any pins appear to bebent.2. With the latch in the open position (see Fig. 42), slide the RAIDController into the enclosure until the latch engages.3. Secure the module by closing the latch. A click should be heardas the latch locks into position (Fig. 43).2.4.4. Disk I/O Module2.4.4.1. Removing the Disk I/O Module1. Grasp the module latch between your thumb and forefinger,and squeeze together to release the latch.2. Pull the latch outward to eject the module from the enclosure(Fig. 44).continued on the next page>>Fig. 42 - Inserting the RAID Controller ModuleFig. 43 - Securing the Module Latch HandleFig. 44 - Releasing the Module Latch Handle
