LaCie 12big Rack Fibre 8 Module Removal & ReplacementUser Manual page 705.4.2. RAID Controller ModuleCAUTION: Handle the module carefully and avoid damaging theconnector pins. Do not install the module if any connector pins ap-pear to be bent.5.4.2.1. Replacing the RAID Controller Module1. Grasp the module latch between your thumb and forefinger,and squeeze together to release the latch.2. Pull the latch outward to eject the module from the enclosure(Fig. 74).3. Using the latch as a handle, withdraw the RAID Controller mod-ule (Fig. 75).5.4.2.2. Installing the RAID Controller Module1. The RAID Controller Modules are installed with the primary (C0)in the upper bay and the secondary (C1) in the lower bay.CAUTION: Handle the module carefully and avoid damaging theconnector pins. Do not install the module if any pins appear to bebent.2. Check for damage, especially to the interface connector.3. With the latch in the open position (), slide the RAID ControllerModule into the enclosure until the latch engages.4. Secure the module by closing the latch. A click should be heardas the latch locks into position (Fig. 76).Fig. 74 - Releasing/Securing the Module Handle LatchFig. 75 - Removing the RAID Controller ModuleFig. 76 - Inserting the RAID Controller Module
