LaCie 12big Rack Fibre 8 Module Removal & ReplacementUser Manual page 715.4.3. Disk I/O ModuleCAUTION: Handle the module carefully and avoid damaging theconnector pins. Do not install the module if any pins appear to bebent.5.4.3.1. Replacing the Disk I/O Module1. Grasp the module latch between your thumb and forefinger,and squeeze together to release the latch.2. Pull the latch outward to eject the module from the enclosure(Fig. 77).3. Using the latch as a handle, withdraw the Disk I/O module(Fig. 78).5.4.3.2. Installing the Disk I/O ModuleThe Disk I/O Modules are installed into I/O bays #1 and #3, referto Fig. 04.CAUTION: Handle the module carefully and avoid damaging theconnector pins. Do not install the module if any pins appear to bebent.1. Check for damage, especially to the interface connector.2. With the latch in the open position (Fig. 79), slide the Disk I/OModule into the enclosure until the latch engages.3. Secure the module by closing the latch. A click should be heardas the latch locks into position (Fig. 77).Fig. 77 - Releasing/Securing the Module Handle LatchFig. 78 - Removing the Disk I/O ModuleFig. 79 - Inserting the Disk I/O Module
