User Manual of LV-D2104CS,LV-D2108CS,LV-D2116CS Series DVR435.1 Configuring Encoding ParametersPurpose:By configuring the encoding parameters you can define the transmission stream type, the resolution and so on.Before you start:1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.(Menu>HDD>General)Figure 5.1 HDD- General2. Check the storage mode of the HDD1) Click Advanced to check the storage mode of the HDD.2) If the HDD mode is Quota, please set the maximum record capacity and maximum picturecapacity. For detailed information, see Chapter 10.5 Configuring Quota Mode.3) If the HDD mode is Group, you should set the HDD group. For detailed information, see Chapter5.9 Configuring HDD Group for Recording.Figure 5.2 HDD- AdvancedSteps:1. Enter the Record settings interface to configure the encoding parameters:Menu>Record>EncodingFigure 5.3 Encoding Parameters-Main Stream2. Set encoding parameters for main stream1) Select Record to enter the main stream settings interface.2) Select the camera for configuration.
