User Manual of LV-D2104CS,LV-D2108CS,LV-D2116CS Series DVR989.2 Configuring Advanced Settings9.2.1 Configuring PPPoE SettingsPurpose:Your device also allows access by Point-to-Point Protocol over Ethernet (PPPoE).Steps:1. Enter the Network Settings interface.Menu > Configuration > Network2. Select the PPPoE tab to enter the PPPoE Settings interface.Figure 9.2 PPPoE Settings Interface3. Check the PPPoE checkbox to enable this feature.4. Enter User Name and Password for PPPoE access.Note: The User Name and Password should be assigned by your ISP.Figure 9.3 PPPoE Settings Interface5. Click the Apply button to save and exit the interface.6. After successful settings, the system asks you to reboot the device to enable the new settings, and thePPPoE dial-up is automatically connected after reboot.You can go to Menu>Maintenance>System Info>Network interface to view the status of PPPoEconnection. Please refer to Chapter 12.1Viewing System Information for PPPoE status.9.2.2 Configuring DDNSPurpose:If your device is set to use PPPoE as its default network connection, you may set Dynamic DNS (DDNS) tobe used for network access.Prior registration with your ISP is required before configuring the system to use DDNS.Steps:1. Enter the Network Settings interface.Menu > Configuration > Network2. Select the DDNS tab to enter the DDNS Settings interface.
