Ultimate-cell Stackable Shaking Incubator V2017.2246.3.1 Switch of Control Mode - Temperature & SpeedThe incubator can be set to run with fixed functional parameters settings, or withprogram up to 9 different segments, each with their own Ramp Time, Ramp EndTemperature, Hold Time and Speed.To select between Fixed Value mode and Programmable mode, follow the belowsteps, Press "Stop" button in the home page to stop the current operation. Enter "FUNC" page. Press the "TEMP MODE" to switch the mode between "FIXED" and "PROG".6.3.2 Switch of Keep Function-Temperature Holding FunctionThis function will enable or disable the system to keep constant temperature, hu-midity and CO2 control at the setpoint once the timer runs out under fixed valuecontrol mode, or at the setpoints of last segment under programmable control model.If it is disabled, temperature, relative and CO2 would be no longer under control asshaking motion stops.To switch this function, follow the below steps, Press "Stop" button in the home page to stop the current operation. Enter "FUNC" page. Press the "KEEP" to enable/disable the temperature holding function6.3.3 Option Switch of Direct Steam Humidification FunctionThis function will enable or disable the direct steam humidity control system.To switch this function, follow the below steps, Press "Stop" button in the home page to stop the current operation. Enter "FUNC" page. Press the "HUMI FUNC" to enable/disable the direct steam humidity function.6.3.4 Option Switch of CO2 Gas Control FunctionThis function will enable or disable the CO2 gas control system.To switch this function, follow the below steps, Press "Stop" button in the home page to stop the current operation. Enter "FUNC" page. Press the "CO2 FUNC" to enable/disable the CO2 Gas control function.Special Remind!Make sure the unit is stopped (by pressing “STOP”) before changing thestate of “TEMP MODE".