Labwit ZWYC-290A User Manual
                                                     | |
Contents
| 
Ultimate-cell Stackable Shaking Incubator V2017.2396.13 Using Sticky MatThe Sticky Mat is used for attaching vessels, such as flaks, bottles, dishes etc ontothe shaking platforms for all shaking equipments, for example, shakers, rockers aswell as shaking incubators. It is as standard 20 x 20 cm in size and can be used tocover the shaking platforms replacing the traditional flask clamps. The Sticky Mat canbe easily removed and repositioned by simply peeling off the shaking tray surface.With proper care, the Sticky Mat can be used for several years.6.13.1 Loading/Unloading the Sticky MatLoad vessels onto the surface of the Sticky Mat by pressing them firmly intodesignated place. Tilt each vessel gently to check that they are adhering firmly.To unload the vessels, tilt the neck of the vessel gently to one side. Wait until thevessel has detached from the Sticky Mat. Large vessels may take about 20-30seconds to be detached.6.13.2 Uninstalling the Sticky MatRelease the Sticky Mat from one side of the tray and then pull upwards at an angleuntil it’s completely detached from the shaking platform.6.13.3 Adhesive StrengthThe Sticky Mat will lose the adhesiveness temporarily when in contact with water, butthe full strength of adhesiveness will come back once it becomes completely dry.Clean up any spills as fast as possible. If water spills comes in contact with the StickyMat, do not start operation until it's dried completely.To ensure the full adhesive strength, the recommended temperature range of theSticky Mat is 18-45°CEnsure the chamber is free of condensation during humidification. The vessels maybecome unstuck from the mat, if there is condensation inside the incubation chamber.ATTENTIONS：1. The Sticky Mat is only used for undamaged,unscratched cultivation vessels with large, clean, dryand flat bottom.2. Make sure the Sticky Mat is undamaged, clean, dryand oil free。ATTENTIONS：For unloading vessels with large bottom, squirt a fewdrops of water along the edge of the vessel. Tilt the neck ofthe vessel gently to one side. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine