Sending Scan Files by Scan to Folder433D Press [OK].E Press [OK].J Press the {Start} key.Note❒ For details about the maximumsize of the scan file that can besent, see p.123 “Scan to Folder”.❒ To interrupt scanning, press the{Clear/Stop} key or press [Stop]on the display panel.❒ When placing multiple origi-nals one-by-one, place the nextoriginal. For details, see p.82“Scanning Originals in SeveralTimes”.Simultaneous Storage andSending by Scan to FolderYou can use the Scan to Folder func-tion and the storage function togeth-er.The scan file is sent by Scan to Folderand at the same time is stored.Note❒ This section explains mainly theprocedure for simultaneous stor-age and sending by Scan to Folder.For details, see p.33 “Procedure forSending by Scan to Folder”.❒ The file stored when simultane-ously storing a file and sending itby Scan to Folder cannot be resentfrom the Scan to Folder screen. Toresend the file, select the file in the[Select Stored File] screen and sendit. See p.54 “Sending Stored Filesby E-mail or Scan to Folder, or De-livering”.A Place originals.Note❒ The procedure for placing origi-nals is the same as that for plac-ing originals for copying. Fordetails about placing originals,see “Placing Originals”, CopyReference.B Make settings for original orien-tation, the sides scanned, and oth-er settings if necessary.Referencep.79 “Making the Settings Relat-ed to the Orientation of theOriginal and Scanned Sides”C Make the scan settings.Note❒ There are two ways to specifyscan settings, as described be-low:• Configure each setting forscanning. For details, seep.77 “Specifying Scan Set-tings”.• Recall registered settings. Fordetails, see p.86 “Recalling aProgram”.D Select the destination.E Specify the sender, subject, andmessage when sending e-mail isperformed at the same time.
