Lantronix SecureLinx User Manual
Also see for SecureLinx: Quick start guideUser guideQuick start guideQuick start guide
                                                               | |
Contents
| 
3: OperationsSecureLinx SLP Remote Power Manager 242. On the subsequent Outlet Traps page, select or deselect the desired traps andpress Apply.ToolsThe Tools section contains access to rebooting the unit, uploading new firmware aswell as resetting the unit to factory defaults. This section is available toadministrative level users only.RestartPerforming a warm boot:1. Select the Restart from the Action drop-down menu and press Apply.Note: System user/outlet/group configuration or outlet states are NOTchanged or reset with this command.Resetting to factory defaults:See Resetting to Factory Defaults for more information on resetting a unit to factorydefaults from the web browser interface.Uploading new firmware:See Uploading Firmware for more information on uploading new firmware from theweb browser interface.Command Line InterfaceLogging InLogging in through Telnet/SSH requires directing the Telnet/SSH client to theconfigured IP address of the unit.Logging in through the Console (RS-232) port requires the use of a terminal orterminal emulation software configured to support ANSI or VT100 and a supporteddata rate (300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 BPS) - 8data bits-no parity-one stop bit and Device Ready output signal (DTR or DSR).To log in by RS-232 or Telnet/SSH:1. Press Enter. The following appears, where x.xx is the firmware version:SecureLinx Power Manager Version x.xxUsername:Note: Logging in by Telnet will automatically open a session. It is notnecessary to press Enter.2. At the Username and Password prompts, enter a valid username andpassword. And press Enter.You are given three attempts to enter a valid username and passwordcombination. If all three fail, the session ends. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine