xPico® Wi-Fi® Embedded Device Server User Guide 305: Interface SettingsLine SettingsThe Line Settings allow configuration of the serial lines (ports). Some settings may be specific toonly certain lines. Such settings are noted below.Note: The settings described below apply to both Line 1 and Line 2 unless otherwisenoted.Table 5-1 Line Configuration SettingsLine Settings DescriptionName Enter a name or short description for the line, if desired. By default, there isno name specified. A name that contains white space must be quoted.State Select to Enable or Disable the operational state of the Line. The default isan enabled state.Protocol Set the operational protocol for the Line. The default is Tunnel for Line 1 andCommand Line for Line 2. Choices are: Command Line Modem Emulation Monitor None Trouble Log Tunnel = Serial-Network tunneling protocol (Line 1 only)Baud Rate Set the Baud Rate (speed) of the Line. The default is 9600.A custom speed or any set speed between 1200 and 921600 may beselected: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400,460800, 921600. If a custom speed is selected, indicate the bits per second inthe field which appears.Parity Set the Parity of the Line. The default is None.Note: Serial lines do not support the following Data Bit/Parity combinations:a) 7 Data Bits with No Parity and 1 Stop Bit.b) 8 Data Bits with 2 Stop Bits.Data Bits Set the number of data bits for the Line. The default is 8.Note: Serial lines do not support the following Data Bit/Parity combinations:a) 7 Data Bits with No Parity and 1 Stop Bit.b) 8 Data Bits with 2 Stop Bits.Stop Bits Set the number of stop bits for the Line. The default is 1.Flow Control Set the flow control for the Line. The default is None. Hardware flow control isonly supported on Line 1.Xon Char Specify the Xon Character which is used when Flow Control is set toSoftware. Set the prefix in one of the three ways: Prefix decimal with prefix hexadecimal and 0x Prefix hexadecimal with 0x Prefix as a single control character with
