Proline Low-temperature ThermostatsYACE0072 / 21.08.07 Interfaces - Modules 1138.5.3 Menu structure contact module (Master)All existing dialogue boxes are illustrated. The Master unit however masks out commands, which cannotbe executed.1%21Actual bath temperatureor actual value ofexternal temperatureLMnet Configuremodulesch&-- Configurecontact moduleE /EEInput switched off TDp : Display module softwareversionch0 X: Display status onInput 1ch1 X: Display status onInput 2ch2 X: Display status onInput 3cm0 X: Display status onOutput 1cm1 X: Display status onOutput 2cm2 X: Display status onOutput 3T13 : Display 24V supplyvoltageRlp^G : Module serial numberPlaces 1-5DlcQuit calibration levelRlp^K : Module serial numberPlaces 6-10RgmYWDisplay levelch1--Set Input 2cm0--Set Output 1ch0--Set Input 1cDE Restorefactory settingsDlcQuit menuch2--Set Input 3cm1--Set Output 2cm2--Set Output 3E Bml Control type on thisinput activatedE @K@ Alarm function on thisinput activatedE Rra Stand-by function onthis input activated E Op5 Programmer functionon this input activatedE r1B Temperature alternat'gmode on this input activatedSelect0, DR, D@ or DO ascontrol sourceE XXXSelect input functionDlcQuit settings level/ODl only for alternat. mode:setpt. temp. on 'contact open'BK/RD only for alt. mode:setpt temp on 'contact closed'/ODl only for control type:type on 'contact open'BK/RD only for control type:type on 'contact closed'E /EEOutput switched offE E0K Refill bath liquid onthis output activatedE ch@Fault diagnosis modeE Rra Stand-by function onthis output activatedE VWh Temperature windowon this output activatedE Op5 Programmer status onthis output activatedE XXXSelect output functionDlcQuit settings levelc XXX only when diagnosisfunc. selected for ouputp 0 only when windowfunction is active : set temp.windowc @KK All alarms,warnings and faultsc KDULow level alarmsc /TrOvertempeature alarmc DppAll fault messages See safety instructionÌ 7.7.3
